HEADLIGHT SERVICE
1. Early models of the Pioneer used a six volt bulb instead of the sealed
beam found in more current machines. If the bulb or sealed beam is
burned out, service is the same, since the bulb should be replaced with
the sealed beam for better lighting.
2. Loosen the screw clamping the chrome ring on the front of the headlight
unit and spread the ends as shown in Figure 14. The wiring connector
can then be disconnected and the defective unit removed. Replace
the sealed beam with a 40/20 unit available from your Ossa dealer.
Reconnect the wiring and fit the rubber ring securely around the unit and
replace in the headlight shell. If both chrome rings have been removed,
note that they fit properly with their flat edges facing each other.
3. Aim the headlight by loosening the bolts holding the headlight shell
to the mounts on the fork tubes. Specifications vary from state to
state so get your dealer's advice if there is any doubt.
|
|