49. Install the ten primary case screws. There are five short screws and five long ones. One of the short screws is 2 or 3 mm longer than the others. Install the screws as shown in Fig. 108.

50. Using a large screwdriver or impact screwdriver, tighten the screws in the sequence
shown in Fig. 108.

51. Place the felt washer onto the selector shaft, then slide the shift lever into place on the shaft. Put a few drops of Loctite on the 10 mm shift lever bolt, screw it into the lever, and tighten it.

FIG. 108
 

Page 75