8. Measure the width of the shift fork grooves in the two sliding gears and the sliding dog (Fig. 40). None of these grooves should measure more than .170". If any of them exceeds this, replace it.

9. Look closely at Fig. 41. It shows the manner and sequence in which the shifter forks are installed in the transmission shafts. The left fork is the first and third gear fork, mounted to the sliding gear on the layshaft. The center one is the second gear fork, mounted to the sliding gear on the mainshaft. The righthand one is the fourth and fifth gear fork, mounted to the sliding dog on the mainshaft.

FIG. 40

FIG.41
 
 

Page 29