thoroughly. Fit the fender to the lower yoke and install all of the
bolts, nuts, and washers. There should be a thick flat washer under the
head of each bolt and a flat washer and lock washer beneath each nut. There
is also a flat fender mount plate that goes beneath the four nuts. It is
a good idea to put a few drops of Loctite on the threads of each nut before
installation. Tighten all of the fender mount nuts and bolts to 6 ft. lbs.
torque.
On Pioneer models the horn and ignition switch bracket must be mounted
under the two forward fender mount bolts. (Fig. 174)
Page 137